CanCam CNC Machines

CanCam is one of the very few CNC providers in Canada to have the company's frames professionally stress relieved. The company heat the entire frame to a temperature of 900 degrees Celsius and hold it at that temperature for 12 hours. furnace is then switched off and the frame is allowed to cool slowly, thus removing all stresses in the fabrication... . After the heat treatment,the company take the frame to the machine shop where a CNC machining center precision machined the bed surface and linear guidway surfaces in one setting. The benefit of machining the entire frame after heat treatment is that the company can machine all the machined surfaces at the same time. Therefore, the company ensures that every important surface on the machine is perfectly parallel and square. Afterall all, a CNC Router can only cut as accurately as it was manufactured. Paint -The company then move the finished machined frame is then moved to the paint shop, where it is carefully prepared for spray painting. The frame is first primed with a red oxide etch primer before the final paint is applied. The company paint the frame is painted on the inside and ouside. Frames range from 6-10mm thickness depending on the model. Motion components - The company uses 20-35mm Hiwin linear guiderails, which have been tried, tested and proven in the market for years, The company offers Yaskawa and Delta servos and drives at very competitive rates as an upgrade from the stepper motor. Spindles & Software - The spindles the company offers with the company's machines are leaders in the industry. Both are Italian made, USA supported HSD and GC Colombo. Each of the company's machines comes with a stylish cabinet, CAD Software at no additional expense.Read More